QS Mentor

Knowledge Centre › QS career & interviews

The QS interview take-off test: a graduate quantity surveyor practical test

QS Mentor Knowledge Centre · QS career & interviews · Updated 2026-11-10 · 5 min read

Many QS interviews include a short take-off: a plan and an elevation of a small unit, and 30 to 60 minutes to measure a few items. Interviewers are checking method as much as answers.

Read everything first

The notes on the drawing usually tell you the rules: where partitions are measured (often on centreline), the deduction rule for openings, what is excluded (a landlord shopfront, for instance) and finish heights. Most lost marks come from skipping the notes.

Set out a dimension sheet

For each item write: description, location, times, length, width, height, and the result. Show the gross figure, then each deduction on its own line. An interviewer can follow it, and so can you when you check.

Classic traps

Check before you hand in

Re-add each column, check units (m, m², m³, nr) and do a rough sense check: floor finishes across all rooms should add up to about the unit area.

QS Mentor includes a café-unit interview take-off with strip-out, partitions, floor and wall finishes, marked line by line. Create a free account.

More guides

General guidance for learning. Contract references are to the published FIDIC forms; your project's particular conditions and the governing law decide. This is not legal advice.